Question: Is it possible to update sd connect C4 without batteries, because I am damaged and batteries do not work !!!.
Answer: It can be done perfectly.
If you need to update an SD Connect and you do not have batteries or
the power supply/charging circuit is damaged, you only have to edit the
toolkit.ini file, modifying the following lines so that the supply
and/or battery voltage is lower to the real (it would be enough to set
them to zero)
Obviously make sure you have a stable and sufficient external supply.
[SoftwareUpdate]
;
; Voltages necessary for SDconnect firmware updates. These values are
only for the pre-check of the toolkit, the values will be checked by the
update process again
;
MinUpdateVoltageVBatt=7200
MinUpdateVoltageVExt=11000
;
A reboot is required for the new settings to take effect (Probably a Tkserver restart is enough)
https://www.cnautotool.com/goods-4990-MB+SD+C4+Star+Diagnostic+Tool+With+Vediamo+V050006+Engineering+Software+Plus+EVG7+Tablet+PC+Support+Offline+Program.html
Question: In which cases an update is urgent?
What is the last version?
Answer: It has not been updated for a long time, generally it is not
necessary to update it, if at first use if it was not. Then I put the
latest versions.
Good to know:
When update the c4 firmware:
Only the best sdconnect C4 plus (supports DoIP) firmware update does not need the battery, here you can go to own one:
https://www.cnautotool.com/category-172-b0-MB+Star+C4.html
When testing the car.
All versions of mb sd connect c4 does not need the battery.
Tips on how to save the battery consumption:
Tip 1: Try to use mux on lan(without wireless card inserted)
Try to use mux on lan(without wireless card inserted),and you will have no more ‘check batteries’ error on display.
seems that error came from heating the wifi card and not correctly drainage from hot air.
Added to this, using mux without wifi card save around 0.4v
consumption, xentry will see around 0.4v more voltage,so safer voltage
for programming,etc… I dont have wifi card installed, better work always
with lan, i dont see too much work in connecting just a cable when
making a work.
i think heat with wifi card is a problem beacouse card itself is
heating adding to the heat that pcb’s itself produces, with no card
installed less heat inside the mux and heat can go exit through the free
slot of card, making a grill on the grey plastic piece will help
allowing heat to go out of mux, surely extending its life.
Tip 2: remove the rechargeable batteries when not using
I did not remove the rechargeable batteries after use I noticed that
some of the inserted batteries went dead after a while. This was (my
personal opinion) because of the continuous battery drainage that pulled
the voltage so low the batteries eventually got broken.
Tip 3: always had with empty batteries often
I always had with empty batteries often because the device was in
standby mode and in the course of time were empty, I have considered a
solution and indeed an on and off switch after the device goes down in
standby mode, I turn it off thus it can not consume power and keep the
batteries.
Tip 4: connecting the mux to a power source
When not in use connecting the mux to a power source (battery
charger). This way the batteries are always getting charged but I’m not
sure if this is a good idea?
Good luck!
www.cnautotool.com
